cpsc bassinet standards
Also, if the mattress is new, pull off that plastic and throw it away immediately. Linking to this external site does not constitute an endorsement of the site or the information it contains by CPSC or any of its employees. While in a rest (non-rocking) position, a bassinet/cradle is intended to have a sleep surface less than or equal to 10 degrees from horizontal. The more significant requirements of AST… The standards adopted the current ASTM International voluntary standards with additional technical modifications. Flatness of segmented mattresses – intended to prevent asphyxiation of an occupant lying face down in a segmented mattress joint. Testing and Certification: Full-size cribs, like all products that are designed or intended primarily for children 12 years of age or younger, must be tested by an accredited third party laboratory accepted by the CPSC for compliance with the full-size crib standard and all other applicable children's product safety rules, including the lead paint, lead content, and phthalate content limits. a clarification of the scope of the bassinet/cradle standard; a change to the pass/fail criterion for the mattress flatness test; an exemption from the mattress flatness requirement for bassinets that are less than 15 inches across; the addition of a removable bassinet bed stability requirement; and. The Consumer Product Safety Commission has approved new safety standards that will protect children as they play and sleep in mesh, portable play yards. The CPSC seeks to promote the safety of consumer products by addressing “unreasonable risks” of injury, doing research into product-related illness and injury, and developing CPSC safety standards. The crib standards cover portable cribs, but not play yards. V. Standards for Crib Bumpers A. In July, the U.S. Consumer Product Safety Commission (CPSC) approved by a unanimous vote to propose that two ASTM International standards covering full-size and non-full-size cribs be incorporated as part of the regulatory requirements of section 104 of the Consumer Product Safety Improvement Act. CPSC staff recommended five modifications to F2194-13 standard. These requirements are discussed below and at www.cpsc.gov/BusinessEducation. ASTM's bedside sleeper standard, ASTM F2906-13 did not include all the modifications that the Commission subsequently made to the CPSC bassinet standard. a change to the stability test procedure, requiring the use of a newborn CAMI dummy rather than an infant CAMI dummy. The Commission's April 2010 NPR assessed the effectiveness of ASTM F2194-07a1. Washington – A new safety standard from the Consumer Product Safety Commission aims to improve cradle and bassinet safety. The CPSC has approved the government’s new federal safety standard for bassinets and cradles. A full-size crib mattress should be at least 27 1/4 inches by 51 1/4 inches and be no thicker than 6 inches. The standards were created to prevent child injuries and deaths caused by these products. This communication has not been reviewed or approved by the Commission, and does not necessarily represent their views. Requires: 4 … ASTM F2194-13, the Standard Consumer Safety Specification for Bassinets and Cradles, contains the specific requirements and descriptions of the required tests and can be purchased from ASTM International. Linking to this external site does not constitute an endorsement of the site or the information it contains by CPSC or any of its employees. Recommended for newborns up to 15 lbs, this Delta Sweet Beginnings bassinet is equipped with locking casters for added safety and for easy room-to-room mobility. CPSC is aware of one international standard that contains performance requirements for crib bumpers/liners: BS EN 16780:2018, Textile child care articles—Safety requirements and test methods for children's cot bumpers. These accessories must meet both the bassinet and cradle standard in addition to the standard for the primary product, like a play yard or non-full-size crib. Effective Date (For most of the rule): April 23, 2014, Effective Date for removable bassinet bed attachments: April 23, 2015. You don’t need a bassinet, but you do need a safe sleep space for your baby. The modifications include: a clarification of the scope of the bassinet/cradle standard; CPSIA emphasized crib safety, making it illegal not only to manufacture or sell cribs that don't meet federal safety standards but also illegal to provide them for use, such as at a hotel or day care. The key provisions of the ASTM bassinets and cradles standard include the following: The ASTM standard also includes: (1) requirements prohibiting small parts; (2) requirements prohibiting hazardous sharp points and edges; (3) unintentional folding requirements; (4) requirements for the permanency and adhesion of labels; (5) requirements for toy accessories to meet ASTM F963 Toy Safety standard (6) scissoring, shearing, or pinching requirements, (7) corner post requirements, (8) requirements for fasteners, (9) requirements pertaining to bassinets that are accessories to play yards or non-full-size cribs, (10) restriction requirement for restraints, (11) openings requirements, (12) protective components requirements and (13) requirements for warnings and instructional literature. ASTM's bedside sleeper standard, ASTM F2906-13 did not include all the modifications that the Commission subsequently made to the CPSC bassinet standard. On Sept.25, 2013, ASTM notified CPSC that ASTM had revised the full-size crib standard. Cardboard boxes for babies are currently not subject to any mandatory safety standards. Raw dried animal hide is not used, Quality leather or cloth is added to each basket. Make sure, too, that the mattress itself is firm, since soft mattresses raise the risk of SIDS. Consumer Product Safety Commission (CPSC) crib standards banning drop-side rail designs for consumer cribs took effect on June 28, 2011 for consumer crib … The CPSC is an active participant in the development of standards covering children’s products. The current version of the standard is ASTM F2194-13. Spacing of rigid components/fabric-sided enclosed openings – intended to prevent entrapment between slats or other rigid components that are under the fabric sides. CPSC does not control this external site or its privacy policy and cannot attest to the accuracy of the information it contains. Federal law requires that bassinets and cradles comply with the bassinets and cradles standard and with additional requirements, including those of the Consumer Product Safety Improvement Act of 2008 (CPSIA). The standard seeks to minimize the risk of deaths and injuries associated with the use of bassinets and cradles, including those related to infant falls, entrapment, or structural and design problems. For example, an estimated 77,300 people were The new federal standard incorporates by reference the voluntary standard (ASTM F2194-13), Standard Consumer Safety Specification for Bassinets and Cradles, with five modifications. As NCLA argued in its opening brief in the Milice case, the CPSC’s failure to make certain standards freely accessible to the public also violates the Constitution of the United States, the CPSC’s organic statute, and the Freedom of Information Act. This is the most recent major recall of a baby furniture. A crib, bassinet, portable crib, or play yard that meets the safety standards of the Consumer Product Safety Commission (CPSC) is recommended along with a tight-fitting, firm mattress and fitted sheet designed for that particular Read NCLA's blog post, "The Real Cost of CPSC’s Hidden Law on New Parents," by Kara Rollins. You may wish to review the privacy policy of the external site as its information collection practices may differ from ours. The link you selected is for a destination outside of the Federal Government. The CPSC is an active participant in the development of standards covering children’s products. Federal law requires that bassinets and cradles comply with the bassinets and cradles standard and with additional requirements, including those of the Consumer Product Safety Improvement Act of 2008 (CPSIA).
Solution For Stray Dogs In Philippines, Covid-19 Causeway Coast And Glens, Abandoned Farms Lancashire, Capitec Graduate Programme, Ruger Precision Cerakote, Oefening Omgaan Met Groepsdruk,
About the Author